小蓝视频

Skip to content

Opinion: What's next with face masks? Keep wearing them in public, wear the best mask available and pay attention to fit

We tested well-fitting cloth masks made from 16 kinds of cotton, on human participants, to see how many provided filtration comparable with a certified medical mask. Most of them did.
covidfacemasks
When health-care professionals are issued N95s or other certified respirators, they are fit tested to verify mask performance on the wearer. But fit testing is typically not an option for the public.

Early in the pandemic, mask-wearing policies were with decreased transmission of SARS-CoV-2. At that time, the masks worn were generally made of cloth and often improvised.

The highly-transmissible Omicron variant .

Although most provinces are lifting official mask mandates, we agree with in recommending that people . We have been working to improve and test reusable masks for community use.

We are an interdisciplinary group of engineers, scientists, a doctor and a community mask-maker. We test novel personal protective equipment (PPE), advocate for mask use and summarize the best available evidence at .

Hierarchy of mask performance

There is an accepted based on mask materials, certification standards and use, confirmed by a . The best protection is obtained by wearing a respirator such as an N95, CAN95 or CAN99, or in Europe, an FFP2 or FFP3. Performance is typically lower for KN95s, KF94s and certified medical masks meeting ASTM . (ASTM is .)

The materials used in all these masks offer similar, excellent, aerosol filtration, but the masks differ in their fit and seal on the face, with KN95s and KF94s fitting better than certified medical masks.

Cloth masks are typically ranked lower in their performance and may or may not be certified (for example, meeting ). However, that well-fitted cloth masks comprising high quality two-ply cotton material can perform as well as Level 1 medical masks.

Fabric types

When health-care professionals are issued N95s or other certified respirators, they are fit tested to verify mask performance on the wearer. But fit testing is typically not an option for the public.

, explained in , underscores that fit can be achieved by good design and is as important as mask materials. For our research, we adapted the same method used in quantitative mask fit testing: a PortaCount fit tester that counts particles inside and outside the mask.

We tested 16 different cottons from nine recognizable categories. All except bandana cotton showed filtration equivalent to a medical mask. These findings apply to the carefully designed two-layer cloth mask with ties we used — other masks that fit less well will not provide the same protection.

Our results show that two-layer cotton masks made from quilters’ cotton, fashion fabric and T-shirt fabric filtered 55 to 60 per cent of aerosol particles measuring one micron or smaller, the size relevant for infectious aerosol particles. This was similar to the performance of a Level 1 medical mask. The breathability of the two-layer cotton masks was also acceptable as per medical mask standards.

Filtration in the same range was provided by batiks, home décor fabric and bed-sheet fabric, but some examples of these materials failed the breathability testing. Tea towel fabrics also filtered well, but some were too thick to sew. Bandana fabrics performed worst at 46 per cent filtration.

Fit and design

Our research showed that cloth masks performed similarly to medical masks because they fit better, were and had overhead ties. Although medical masks are composed of materials with better filtration performance, they exhibit greater leakage, with completely unfiltered air passing around the mask.

The cloth masks included in past studies may have been haphazardly selected: their filtration, using the same methods that we used, was found to be and . A thoughtfully designed two-layer T-shirt mask with overhead ties, tested on human volunteers, filtered , in keeping with our study, and again highlighting the importance of fit.

To compare like with like, when we looked at other studies, the filtration percentages that we quote above were taken from studies using a similar design: protection of a human wearer, using particles , . Other studies examining , using and using come to similar conclusions.

Good masks fit well, with minimal obvious leaking at the edges. or all . or more, and a middle layer of non-woven improve overall filtration.

for community masks, , are likely to filter well, though generally not as well as respirators.

N95 masks

Hospitals report that the current supply of N95-type masks meets but doesn’t exceed demand, and supply of these masks is insufficient for the general population. Access and cost issues require public health and economic solutions along with consideration of of disposable PPE.

If for personal use, we recommend buying only what you need and practising . If buying KN95s and equivalent certified medical masks, we advise paying close attention to the fit of the mask. We recommend medical masks or using minor modifications or that enhance fit and reduce leakage.

, , multilayer reusable cloth masks still have an important ongoing role in reducing transmission of SARS-CoV-2, especially in lower risk settings.

Protection is highest and transmission is lowest when , because masks both protect the wearer while also (source control). There are important reductions to individual risk from wearing any mask, which have been and . We can protect ourselves, others and vulnerable people. Let’s all wear the best mask available.

Rebecca Rudman, co-founder of the and member of McMaster’s Cloth Mask Knowledge Exchange, and Amanda Tomkins, an undergraduate student in engineering at McMaster University, co-authored this article.

The Conversation

Catherine Clase is a member of the Cloth Mask Knowledge Exchange, a research and knowledge translation group that includes industry stakeholders. Industry stakeholders contribute to the Cloth Mask Knowledge Exchange by contributing to grant funding, and through in-kind contributions of time and expertise. Industry stakeholders make masks and distribute polypropylene and other fabrics. They may potentially benefit from this article. She is a member of McMaster's Centre of Excellence in Protective Equipment and Materials, and editor-in-chief of clothmasks.org. Catherine has received consultation, advisory board membership or research funding from the Ontario Ministry of Health, Sanofi, Pfizer, Leo Pharma, Astellas, Janssen, Amgen, Boehringer-Ingelheim and Baxter. In 2018 she co-chaired a KDIGO potassium controversies conference sponsored at arm's length by Fresenius Medical Care, AstraZeneca, Vifor Fresenius Medical Care, Relypsa, Bayer HealthCare and Boehringer Ingelheim. Catherine Clase receives funding from CIHR, and is a member of the Green Party, the American Society of Nephrology, the Canadian Society of Nephrology, the American Association of Textile Chemists and Colorists and ASTM International.

Charles-Francois de Lannoy receives funding from the Natural Sciences and Engineering Research Council (NSERC) of Canada, the Global Water Futures (GWF) Research organization, Ontario Centres of Excellence (OCE), Federal Economic Development Agency for Southern Ontario (FedDev), Canadian Foundation for Innovation (CFI), the French Embassy, and McMaster University. He has received funding in partnership with Pall Water, Trojan Technologies, Hatch Ltd., and PW Fabrication. He has engaged in various research projects and testing/validation of facemasks for several private companies in Ontario. He is affiliated with the Cloth Mask Knowledge Exchange as an expert advisor.

Ken G. Drouillard receives funding from Natural Sciences and Engineering Research Council of Canada (NSERC), Ontario Ministry of Environment, Conservation and Parks, Environment and Climate Change Canada, Great Lakes Fisheries Commission, WE-SPARK Health Discovery Institute, University of Windsor, City of Windsor. He is affiliated with the Detroit River Canadian Clean-Up Committee and holds membership with International Association for Great Lakes Research.

Scott Laengert does not work for, consult, own shares in or receive funding from any company or organisation that would benefit from this article, and has disclosed no relevant affiliations beyond their academic appointment.

push icon
Be the first to read breaking stories. Enable push notifications on your device. Disable anytime.
No thanks